Many people have heard of the coating process of vacuum magnetron sputtering coating machine, and probably only know that its function is coating, but everyone does not know its coating principle and process, why it can be coated with exquisite films, including the later stage. How should the staff in the field choose, or plan their later development, everyone believes that only if you have a detailed understanding of the industry, so that you can make the right choice.

First of all, I will explain the coating process of the vacuum magnetron sputtering coater to let everyone know how those beautiful films are plated. Generally, before coating, the machine must be vacuumed first, and the vacuuming process must be heated. The heating temperature depends on the material of your workpiece 3. When the vacuum degree reaches high vacuum, generally around 0.005Pa, start the argon ion bombardment cleaning, use the main arc of the arc target to bombard and clean, then use the mixed primer with the arc and the magnetron target and use the magnetron target to primer, and then pass Enter the material to be plated, and finally cool down and release it, and the entire coating process is completed. Many people feel that the coating process is very complicated and has a high technical content. In fact, it is not. As long as you figure out the details of the coating process and the coating process, and then put your energy into it, it is actually very easy to get started. A newcomer who has just started, he is full of enthusiasm, wants to enter the coating industry, wants to learn techniques, but does not understand what techniques he wants to learn. It is the technology of coating process technology and coating equipment. Many newcomers do not have a deep understanding of this industry. They confuse the two, but there is a big difference between the two, especially for newcomers who have just entered the industry. Remember and pay attention.
In terms of coating, in fact, there is not much difference between domestic and foreign in terms of decorative coating. The domestic vacuum magnetron sputtering coating machine is slightly cheaper, but the quality of the coating can be achieved very well. There is a big gap between domestic and foreign tool coating. Foreign tool coating companies basically sell equipment, and then the equipment is equipped with technology, but domestic manufacturers have little experience in this area. As for the later treatment, if you can be a master craftsman, I think the salary level is at least 5,000 or more, but if you are an engineer in equipment, if you have better skills, the treatment will be higher.